The visual of our 6” X 48” HomeStyle Nation Classic Ceiling Plank delivers an incredible country rustic appear. Here is the ugly popcorn ceiling prior to we started, displaying our grid lines, marking exactly where the ceiling joists are. You can speed up your beadboard install by getting your material finished prior to installing it. I primed all six sides of the material prior to installing it. This is especially essential if you plan to paint the beadboard ceiling immediately after the install. Tapping the boards not only tightens the tongue and groove joint, but tightens the nails of the boards already installed. The beadboard ceiling boards must be installed perpendicular (oriented at a 90-degree angle) to the joists.
Prior to installing any boards, you need to mark the location of the ceiling joists on the existing ceiling employing a chalk line or similar. Whilst operating beaded boards perpendicular to ceiling studs is generally not a dilemma, it offers challenges for a wainscot style application on walls. Making use of a stud finder or other system, locate and mark your ceiling joists prior to starting board installation. I have been living in a modular residence for the previous eight years and hate the popcorn ceilings and bare walls.
Manufactured exterior grade beadboard planks and paneling that might execute superior. When ordering beaded ceiling boards, order boards extended enough to stay away from lengthwise seams. Once again, beadboard ceiling constructed working with three/4″ x 4″ beaded pine tongue and groove boards painted white. To tighten the boards prior to nailing, use a scrap piece of the tongue and groove board as a tapping block and firmly pound on it with a hammer. We nail them along the back edge only so that it’s easier to click the next row of planks into the tongue on the previously installed row.
Expansion gaps on the tongue and groove (start out to finish) sides of the ceiling are significantly less significant because of the slight expansion permitted between the tongue and groove joints. The ceilings are a distinct story, and I’ve been considering about wood plank, not only due to the fact it would look good (and update the house), but because it’s not all that tough to install (and we’ve accomplished a lot of installation of various things lol). For our cabin beadboard ceilings, we utilized 3/4″ x 4″ beaded tongue and groove pine boards. Just apply Liquid Nails to the back of every single board, then nail with a nail gun into the ceiling joists.
When calculating the quantity of material to order, bear in mind that 4″ beaded tongue and groove boards supply only 3 1/2″ of a completed surface due to the tongue. We’ve removed all the popcorn ceiling in our renovating also, but have the master left to do. I’ve constantly loved planked ceilings and we’ve talked about this as an option when we get to the master. We did it a couple of days ahead of this post was published (June 1) and they’ve nonetheless got a whole end cap full of ’em at our regional Lowes. If you do it your self the expense is about $.97 to $1.50 per square foot.
