Installing beadboard ceilings in your cabin or household is an effortless way to add vintage-really feel and character. Expansion gaps on the tongue and groove (start to finish) sides of the ceiling are much less critical simply because of the slight expansion allowed between the tongue and groove joints. The ceilings are a distinct story, and I’ve been considering about wood plank, not only mainly because it would look nice (and update the residence), but since it is not all that tricky to set up (and we’ve done a lot of installation of different items lol). For our cabin beadboard ceilings, we utilized three/4″ x 4″ beaded tongue and groove pine boards. Just apply Liquid Nails to the back of every single board, then nail with a nail gun into the ceiling joists.
Nowadays our carpenter cut out the original front porch ceiling and is raising it. We are going with a barrel vaulted ceiling. Use a caulk line or straight edge to mark the location of all joists on the whole length of the ceiling. We ran our planks in the opposite direction of the ceiling joists and puttied as several holes as we could ! Nail the board at each edges and the intersection of just about every joist (which need to be marked on the ceiling with chalk or a line). To make it easier to rip the final board, join the piece to be reduce into yet another tongue and groove board.
You can not see it standing on the floor, but when you are on the top of a ladder, up close and personal, seeking across the ceiling, you can see it. Which signifies your planks will most likely have a little bit of waffle” in those exact same spots. I discovered this solution at Lowe’s and am going to do my daughter’s kitchen ceiling as it is TERRIBLE! Bostitch pneumatic finishing nailer and 16 gauge 2″ finishing nails employed to blind nail the tongue and groove boards. Install the very first board tongue out with the groove side of the board facing the wall.
Attach planks directly to existing joists or more than drywall or plaster ceilings utilizing the clips and screws included in every plank carton. You can click on the word LOWES in this post to take you to the page they’re on on Hope that aids! Starting on a single side of the room, we placed the tongue side of the board against the wall, for our initially row, going across the joists.
If cost is not a consideration, I would propose going with a greater grade of wood. To cover the expansion gap involving the ceiling and the walls and to finish the covers, add trim. All that is left is caulking about the edges exactly where the planks meet the crown moulding, and also some random seams where we had to use a shorter board in order to get it to match. With a distinctive clip method, made especially for Armstrong’s WoodHaven wood-appear ceiling planks, installation is created simple. If you will need to seam boards, order finish-matched boards that have tongue and groove sides created for seaming.
