New decorative molding to finish off the edge of the tiles utilized for backsplash. Anytime a ceiling fan is to replace an ordinary light fixture, then, it is important to confirm that the box it is to be hung from is rated for ceiling fans, and this usually suggests replacing the current ceiling electrical box, so lets start out there. Metal ceiling tiles are substantially lighter and less complicated to set up than regular plaster ceilings.
After you discover this location, you will need to have to get up in the attic, and locate where your spot is. You want to make positive your place is between 2 trusses, so that you can install the suitable hardware and the help will be there to handle the weight of the fan. Replaced a fan we had devoid of a light that was currently wired correctly, so extremely simple to put up. Really quiet as well. Ahead of you commence installing the fan make sure to disconnect the power by removing fuses or turning off circuit breakers. A piece of half inch or thicker plywood fastened to the joists will hold your fan.
Make sure the installation web-site you select makes it possible for a minimum clearance of 7 feet from the blades to the floor and at least 30 inches from the ends of the blades to any obstruction. It could be easier just to find a hot wire in the attic that is close to the location exactly where you want to set up the fan, and employing a junction box, splice onto the current hot wire with some 14/2 romex and run this to the new fan outlet box. Before assembly the bearings in your ceiling fan are oiled and then encased, along with the motor, in a housing.
For the finest circulation the blades ought to be at least 7 feet from the floor, and 2 feet from the ceiling. You can follow the basic instructions that are below if you already have a light fixture in the ceiling. If access is possible above the ceiling where the box is located it is a straightforward job to replace the existing box with one particular rated for ceiling fans. Particular boxes are available for mounting by way of a hole in the ceiling they have expandable bars that will reach out to the joist on either side of the hole and by turning a nut on the bar will be pressed against and into the adjacent joists.
Ideally, the blades need to be at least two feet from each and every wall and at least 7 to eight feet from the floor. If you have an current ceiling light, I recommend to get a ceiling fan with remote control or lengthy chain switch access and connect your wiring to that light junction box. Metal ceiling tiles are perfect for covering unsightly plaster ceilings that are in want of repair.
